Single phase line protection for Schuko.
This SPD is plugged directly in the same socket as the load to be protected.
Installation
To be installed in parallel with the loads plugged into the same socket. Its use is recommended in systems where overvoltage sensitive equipments are installed (computers, printers, servers, etc.) and always coordinated with protector type 1 or 2.
It contains an effective protection based upon suppressor diodes against transient overvoltages, aimed towards single-phase power supply lines.
Tight protection according to scaled protection recommended in Low Voltage Regulation (REBT ITC23). Its installation is simple, complementing the load to protect no matter where it’s placed.
Tested and certified as Type 3 protectors according to regulations EN 61643-11 and GUIDE-BT-23 from REBT. Suitable for Categories I, II, III and IV equipment according to ITC-BT-23 from REBT.
- Coordinable with other SPDs such as ATSHOCK, ATSHIELD, ATSUB and ATCOVER.
- Short response time.
- Discharge takes place in an internal encapsulated element, with no external flash.
- No interruptions in power supply, thus avoiding data loss and other inconvenient for the user.
- Thermic control device and visual warning. When the protector it OK the green light its on. When there is a failure the light turns off.
AT96 SPDs have been tested in official, independent laboratories, obtaining their characteristics according to relevant standards (related in the table).
Technical Datasheet Atplug
| Reference | ATPLUG AT-9601 |
| Protection categories according to REBT: | I, II, III, IV |
| Loại phép thử theo EN61643-11: | type 3 |
| Nominal voltage: (Un) | 230VAC |
| Maximum working voltage: (Uc) | 255VAC |
| Nominal frequency: | 50-60Hz |
| Nominal discharge current (wave 8/20μs): (In) | 3kA |
| Combined wave tension: (Uoc) | 6kV |
| Protection level at In (8/20μs wave): (Up(In)) | 800V |
| Response time: (tr) | <10ns |
| Working temperature: | -400C to +700C |
| Dimensions: | 105 x 90 x 59mm |
| SPD locatiion | Outdoor |
| Type of connection: | Parallel (one port) |
| Number of poles: | 2 |
| Enclosure material: | ABS |
| Enclosure protection: | IP20 |
| Insulation resistance: | >1014Ω |
| Autoextinguish enclosure: | V-0 Type according to UNE-EN 60707 (UL94)) |
| Certificated tests according to: IEC 61643-1, EN 61643-11 Complies with requirements of: UL 1449 Relevant standards: UNE 21186, NFC 17102, IEC 62305 |
|
